Minisforum N5 Air 10-inch rack carrier (5U)

Four printed parts: N5Air_wall_left, N5Air_wall_right, N5Air_floor, N5Air_brace. STL files are in millimetres.
Print the walls lying on their outer face (footprint 260 x 222 mm), the floor flat (240 x 203 mm), the brace flat.
No supports. PETG or ASA. 10 x M3 heat-set inserts (4 mm holes): 8 in the walls' bottom rails, 2 in the brace ends.
10 x M3x8 screws: 8 up through the floor into the rails, 2 through the walls into the brace.
The NAS slides in from the front; the rear corner stops keep it from sliding back. 2 mm side clearance,
3.75 mm under the top rails. Total depth 260 mm; the NAS rear sits 5 mm inside the stops.

Untested prototype designed around Minisforum's published 199 x 202 x 252 mm envelope. Not printed, load tested
or thermally tested. Check the feet and vents of your unit against the floor plate before printing.
Source: scripts/assets/create_minisforum_n5_air_mount.py in the minirack.cc configurator (all dimensions in PARAMS).
