Protectli VP6630 10-inch 2U carrier — original Minirack prototype

FILES
protectli-vp6630-2u-mount.stl: printable geometry, dimensions in millimetres.
protectli-vp6630-2u-mount.blend: editable mount only, dimensions in metres.
The display VP6630 device is not included in the print file.

DESIGN
254 mm wide, 186 mm deep, 88.4 mm high; 2U rack occupancy.
Designed around Protectli's published 191 x 178 x 76 mm chassis envelope.
194 mm clear width between the side guides; 4 mm deck and front plate.
Mounting hole centres are 236.6 mm apart horizontally. Each side has
six 6.6 mm-high obround holes, with 2 mm additional horizontal adjustment.
Vertical hole centres above nominal U bottom: 6.35, 22.225, 38.1, 50.8,
66.675 and 82.55 mm. The face has 0.25 mm clearance above and below 2U.
The ventilated deck, low side guides, front rim and rear stop cradle the unit.
Two side gussets reinforce the face-to-deck joint. Optional retention ties
can use the side slots; keep ties clear of fans, fins and connectors.
The top and rear are open. The power supply is not supported by this carrier.

PROTOTYPE STATUS
Not physically printed, fitted, load tested or thermally tested.
The STL is a closed manifold mesh, and the current device display model does
not intersect it. That does not establish real-world fit or load capacity.
The appliance is specified at 2.3 kg. Verify rail spacing, clearances,
material/temperature suitability and loaded behaviour before service.
Inspect the model in your slicer: the upper front crossbar and mounting
holes may need supports depending on print orientation. A single-piece
254 x 186 mm footprint needs a sufficiently large bed, including margins.
Do not scale the whole STL to fit a smaller bed: that changes device fit
and rack mounting pitch. Modify the design instead.

DIMENSION REFERENCE
https://protectli.com/wp-content/uploads/2025/12/VP6630-Datasheet-20251215.pdf

CREATOR
Minirack. This is a new design, not a resized or redistributed copy of the
19-inch Printables adapter. No manufacturer endorsement is implied.
